760-943-8675 pkohl@zwiesler.com

HHT Hand-held Programming Unit
for SBC-2400 Traffic Controller

Sets Timing and Configuration Functions of SBC-2400 Traffic Controller
with TRIP Software or WI4KS/SBC Wapiti Software

HHT Programmer to Set Timing and Configuration Functions

  • Low cost and efficient hand held terminal
  • 18-key hex keypad
  • 20-character by 4-line LCD display
  • No batteries (power is provided by the interface connector)
  • Easy learning curve for key codes.

The HHT Programming Unit is used to program the SBC-2400 Traffic Controller, providing the required data entry keypad and alphanumeric LCD display. Only one unit is required for use with multiple controller. Recommended for use with the HHT Programming unit are the following:

Input Simulator Box. Allows an SBC-2400 Controller to be exercised for proper programming, with no need to connected to an actual intersection.

A Signal Output Test Display. Shows the signal outputs of the SBC-2400 controller. This Display consists of 8 Signal Groups, each with Green, Yellow and Red LEDs.

Cost-Effective Traffic Control Solutions for International Markets

220 Via del Cerrito
Encinitas, CA 92024, USA

Tel: 760-943-8675
Fax: 760-943-8675
pkohl@zwiesler.com