Solar Powered & Cost Effective
Traffic Control Solutions

Home Page Products Capabilities Key People Dealer Network Contact & Inquiry

HHT Hand-held Programming Unit
for SBC-2400 Traffic Controller

Sets Timing and Configuration Functions of SBC-2400 Traffic Controller
with TRIP Software or WI4KS/SBC Wapiti Software

HHT Programmer to Set Timing and Configuration Functions

  • Low cost and efficient hand held terminal
  • 18-key hex keypad
  • 20-character by 4-line LCD display
  • No batteries (power is provided by the interface connector)
  • Easy learning curve for key codes.

The HHT Programming Unit is used to program the SBC-2400 Traffic Controller, providing the required data entry keypad and alphanumeric LCD display. Only one unit is required for use with multiple controller. Recommended for use with the HHT Programming unit are the following:

  • Input Simulator Box. Allows an SBC-2400 Controller to be exercised for proper programming, with no need to connected to an actual intersection.
  • A Signal Output Test Display. Shows the signal outputs of the SBC-2400 controller. This Display consists of 8 Signal Groups, each with Green, Yellow and Red LEDs.
HHT Traffic Signal Controller by Zwiesler Resources


SBC-2400 Single Board Controller System

 SBC-2400 Controller CPU
 SBC-2400 Traffic Software
 Software Manual
 HHT Programming Unit
 SBC-2400 Test Equipment
 SSC Power Board
 CMU Conflict Monitor Unit
 Cabinet Power Supply
 Loop Detectors
 Traffic Cabinets

Zwiesler Resources Inc. Capabilities

 Solar Power for Traffic
 Zwiesler Home Page
 Contact ZRI

Cost-Effective Traffic Control Solutions
for International Markets

Tel:  760-943-8675
Fax: 760-943-8675

220 Via del Cerrito
Encinitas, CA 92024, USA

2008 Zwiesler Resources, Inc.. All rights reserved.

home4.jpg (3210 bytes)